AeroAudio HPH AMP AES67 TM 매뉴얼 - 페이지 4
{카테고리_이름} AeroAudio HPH AMP AES67 TM에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AeroAudio HPH AMP AES67 TM 9 페이지.
페이지 인쇄
RAV2SAP
software
HP AMP AES67 TM
MANUAL
By default AES67 is enabled. You can use the Ravenna RAV2SAP control software to
enable any AES67 streams to be shown in the Dante™ controller software.
The latest version of the RAV2SAP software and manual can be downloaded from
the official Ravenna-network website at: www.ravenna-network.com.
Device configuration
The HP-AMP-AES67 supports sample rate conversion. Since by default AES67 is
enabled, this option is only available when AES67 has been disabled.
By default encoding is set to PCM 24 bit to match optimal encoding of the DA
converter.
Encoding can be changed but can result in loose of audio quality. AeroAudio strongly
advices to leave encoding at PCM24 bit.
Where needed Unicast delay requests can be enabled.
Delay is set by default to minimum at 1mS. This can be adjusted upto 5mS, but is not
recommended.
STEENWEG 148C - 9810 NAZARETH - BELGIUM - T +32 (0)9 396 76 40 - [email protected]