AeroAudio HPH AMP AES67 TM Manuel - Sayfa 4

Amplifikatör AeroAudio HPH AMP AES67 TM için çevrimiçi göz atın veya pdf Manuel indirin. AeroAudio HPH AMP AES67 TM 9 sayfaları.

RAV2SAP

software

HP AMP AES67 TM

MANUAL

By default AES67 is enabled. You can use the Ravenna RAV2SAP control software to

enable any AES67 streams to be shown in the Dante™ controller software.

The latest version of the RAV2SAP software and manual can be downloaded from

the official Ravenna-network website at: www.ravenna-network.com.

Device configuration

The HP-AMP-AES67 supports sample rate conversion. Since by default AES67 is

enabled, this option is only available when AES67 has been disabled.

By default encoding is set to PCM 24 bit to match optimal encoding of the DA

converter.

Encoding can be changed but can result in loose of audio quality. AeroAudio strongly

advices to leave encoding at PCM24 bit.

Where needed Unicast delay requests can be enabled.

Delay is set by default to minimum at 1mS. This can be adjusted upto 5mS, but is not

recommended.

STEENWEG 148C - 9810 NAZARETH - BELGIUM - T +32 (0)9 396 76 40 - [email protected]