American Rotary AMP 10 사용자 설명서 - 페이지 3
{카테고리_이름} American Rotary AMP 10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. American Rotary AMP 10 18 페이지.
페이지 인쇄WARNING + SAFETY INFORMATION
DANGER: HIGH VOLTAGE
DANGER: RISK OF ELECTRIC SHOCK
This manual is to serve the purpose of providing recommendations for proper performance but is not to
supersede or replace local or national electric codes . Installation should be done by a licensed electrician who is
familiar with phase converter installations .
WARNING! READ BEFORE STARTING CONVERTER!
If this phase converter does not start in less than 2 seconds, TURN IT OFF and verify the following listed below .
1 . This manual covers the installation and proper
wiring for 208-240v
208-240v only . If you have 480v or any
other voltage than listed above, incoming power
do not install this unit and call American Rotary .
2 . Make sure the wire size meets or exceeds our
minimum recommended size .
3 . All loads, INCLUDING TRANSFORMERS, must
be DISCONNECTED before starting the phase
converter each time . American Rotary offers
a variety of manual and automatic disconnect
options . Please visit AmericanRotary . c om or call
1-888-743-6832 for assistance .
If your converter still takes more than 2 seconds
to start, call our Toll-Free Technical support
line 1-888-743-6832 . You will be asked to verify
conditions 1 and 2 above are met . Failing to meet
these two conditions account for 99% of starting
problems and can result in damage to the
starting capacitors .
This converter is much quieter than an off the
shelf three phase motor . If for any reason it does
not sound like it is running smoothly, TURN IT
OFF and call American Rotary Technical support .
(Please note that there is a break-in period of 100
hours .)
3 | User Manual R2 .3
Electric shock could result in death or injury . Please consult qualified
personnel for installation .
Please wait 30 minutes before servicing .
4 . Make sure the Phase Converter Panel, the electric
generator/idler and your equipment is grounded!
5 . Before connecting the load, verify proper function
of phase converter . This will ensure the protection
of the phase converter and your equipment .