American Sportworks 3171 소유자 매뉴얼 - 페이지 5

{카테고리_이름} American Sportworks 3171에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Sportworks 3171 12 페이지. 136cc fun kart

페이지 인쇄

SECTION

A. Operation controls

WARNING

Do not attempt to start or operate the engine until completely familiar with the location and use of each control

necessary to operate this vehicle. The operator must know how to stop this machine before starting and driving it.

B. Throttle

The right foot pedal is the throttle, controlling the speed of the kart . As the engine speed increases above idle, the clutch automatically engages and moves the vehicle

forward . To disengage the clutch at any time, allow the throttle to return to the idle position . (see figure 2 .1 below)

WARNING

Every time, prior to starting the engine, check the throttle assembly to ensure that when the pedal is pushed all the

way forward the assembly is working smoothly and returns to idle when released. Do not operate this unit if pedal

or engine throttle linkage fail to return to the idle position. If unable to correct the problem through lubrication,

adjustment or replacement of worn parts, contact your dealer for assistance.

C. Fuel Valve

(see figure 2.1)

The manual valve is mounted to the bottom of the fuel tank .

Refer to the Engine Manufacturer Operation Manual . The

fuel valve location can be seen in figure 2 .4 . NOTE: Turn fuel

valve to OFF position during transport

D. Brake

The brake is controlled by the left foot pedal (see figure 2 .2) .

Applying pressure to the pedal draws the brake pads against

the brake disc at the wheels and slows or stops the kart .

The locking lever can be applied to act as a park brake and

should remain applied during starting and engine warming

(choke cycle) .

E. Engine Starting

Apply foot brake and ensure the Engine Stop Switch

is in the RUN/ON position . Have a supervisor start the

engine by applying the choke, located on the engine,

then pulling the recoil starter . NOTE: Your Fun-Kart

is equipped with (2) engine stop switches, one

located on the dash and one located on the engine

electrical cover. BOTH switches must be in the

"RUN/ON" position for the engine to start. The

engine will warm up within 5 minutes, allowing the

engine to operate at the normal RPM . The choke may

be closed at this time . On a warm day, this period of

time may be reduced to less than 1 minute .

F. Engine Stop Switch

This vehicle is equipped with 2 Engine Stop Switches

for added safety . One is located on the steering column

(see figure 2 .2) and the other is located on the engine

(see figure 2 .4) . Before driving this vehicle, test the

Engine Stop Switches to ensure that they are operating

properly . With the engine running, switch the Engine

Stop Switch to the STOP/OFF position to shut down

the engine . The stop position may be identified on the

switch by the word "STOP", the word "OFF" or the

symbol " "

KART OPERATION

figure 2 .2

3171 OWNERS MANUAL

operation

figure 2 .1

fuel valve

in "ON"

position

Engine stop switch

Brake pedal

Throttle pedal

15023R1 rev. A

pub. 05/19/2015