American Sportworks 3171 Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pojazd użytkowy American Sportworks 3171. American Sportworks 3171 12 stron. 136cc fun kart
SECTION
A. Operation controls
WARNING
!
Do not attempt to start or operate the engine until completely familiar with the location and use of each control
necessary to operate this vehicle. The operator must know how to stop this machine before starting and driving it.
B. Throttle
The right foot pedal is the throttle, controlling the speed of the kart . As the engine speed increases above idle, the clutch automatically engages and moves the vehicle
forward . To disengage the clutch at any time, allow the throttle to return to the idle position . (see figure 2 .1 below)
WARNING
!
Every time, prior to starting the engine, check the throttle assembly to ensure that when the pedal is pushed all the
way forward the assembly is working smoothly and returns to idle when released. Do not operate this unit if pedal
or engine throttle linkage fail to return to the idle position. If unable to correct the problem through lubrication,
adjustment or replacement of worn parts, contact your dealer for assistance.
C. Fuel Valve
(see figure 2.1)
The manual valve is mounted to the bottom of the fuel tank .
Refer to the Engine Manufacturer Operation Manual . The
fuel valve location can be seen in figure 2 .4 . NOTE: Turn fuel
valve to OFF position during transport
D. Brake
The brake is controlled by the left foot pedal (see figure 2 .2) .
Applying pressure to the pedal draws the brake pads against
the brake disc at the wheels and slows or stops the kart .
The locking lever can be applied to act as a park brake and
should remain applied during starting and engine warming
(choke cycle) .
E. Engine Starting
Apply foot brake and ensure the Engine Stop Switch
is in the RUN/ON position . Have a supervisor start the
engine by applying the choke, located on the engine,
then pulling the recoil starter . NOTE: Your Fun-Kart
is equipped with (2) engine stop switches, one
located on the dash and one located on the engine
electrical cover. BOTH switches must be in the
"RUN/ON" position for the engine to start. The
engine will warm up within 5 minutes, allowing the
engine to operate at the normal RPM . The choke may
be closed at this time . On a warm day, this period of
time may be reduced to less than 1 minute .
F. Engine Stop Switch
This vehicle is equipped with 2 Engine Stop Switches
for added safety . One is located on the steering column
(see figure 2 .2) and the other is located on the engine
(see figure 2 .4) . Before driving this vehicle, test the
Engine Stop Switches to ensure that they are operating
properly . With the engine running, switch the Engine
Stop Switch to the STOP/OFF position to shut down
the engine . The stop position may be identified on the
switch by the word "STOP", the word "OFF" or the
symbol " "
2
2
KART OPERATION
figure 2 .2
3171 OWNERS MANUAL
operation
figure 2 .1
fuel valve
in "ON"
position
Engine stop switch
Brake pedal
Throttle pedal
15023R1 rev. A
pub. 05/19/2015