Bob's Space Racers BSR-3000 보드 설정 - 페이지 5
{카테고리_이름} Bob's Space Racers BSR-3000에 대한 보드 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Bob's Space Racers BSR-3000 8 페이지.
페이지 인쇄Please Note: Read all the instructions before performing any procedures.
Plug in all the cables. See Figure 2.6.
2.1.4
Network
Power
Connector
Go to the Master board and enter programming mode by mode pressing and holding the Select
2.1.5
and Enter on the Master board (Figure 2.7) until Figure 2.8 is visible.
seconds).
Release the two buttons
2.1.6
Please Note: There is a safety protocol. Two minutes after entering into program mode it will exit automatically. If it
exits before accomplishing the procedure the master saves the last entry. Simply re-access program mode and continue
where it timed out.
Figure 2.7
The Spare Unit board's ID will now show 33 as seen in Figure 2.9.
2.1.7
Figure 2.9
Bob's Space Racers® Inc. ©2017
G
AME POWER MUST BE ON TO PERFORM THIS OPERATION
Cables
Select Enter
Figure 2.6
.
Network
Cables
1. Each connector is keyed.
2. Connections may vary per game.
(This should be about 5
Figure 2.8
P a g e
| 5