Bobrick B-38030 설치 및 유지보수 지침 - 페이지 5

{카테고리_이름} Bobrick B-38030에 대한 설치 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bobrick B-38030 6 페이지.
Bobrick B-38030에 대해서도 마찬가지입니다: 설치 및 유지보수 지침 (9 페이지)

페이지 인쇄

ELECTRICAL CONNECTION OF HAND DRYER:

Electrical supply entry holes are located in the rear of the cabinet at lower

right corner of the dryer mounting base and at the right side of the cabinet.

Supply cable with supplementary insulation into one of these locations in

the unit cabinet. Cabinet should be fitted with a conduit connection. Plastic

grommet supplied to use as necessary.

1. Connect dryer to nearest distribution panel. Use wire as required

by local electrical code, 3.31mm² dia. (No. 12) wire or larger.

2. Wiring Instructions:

This appliance is intended for connection to fixed wiring.

b. A fused means for disconnection in all poles must be provided

in the fixed wiring in accordance with the wiring rules.

Check that the electrical rating shown on the dryer (rating

label) is compatible with the electrical supply.

d. WARNING: THIS PRODUCT MUST BE GROUNDED

(EARTHED).

Installation and wiring must conform to current IEE

Regulations (UK), local or appropriate regulation (other

countries).

For 115-Volt dryers: Connect ground wire to ground terminal

marked

, the black or hot wire to terminal marked L1, and neutral or

white wire to terminal marked N

For 208–240 Volt dryers: Connect ground/earth supply the terminal marked

marked L (L1) and N (L2).

3. Secure electrical wire in strain relief clamp provided on mounting base.

CHECK DRYER OPERATION:

1. Turn electrical power supply on.

2. Position hands under air outlet, within 100mm (4") of air outlet opening.

3. Dryer should turn on. Warm air should blow from air outlet.

4. Remove hands from under air outlet and dryer should stop (within 2 seconds).

GENERAL OPERATING CONDITIONS:

The following minimum machine operating environmental parameters must be met in order to allow proper dryer operation:

1. The equipment will operate correctly in its intended ambient operating temperature range, at a minimum, between

+5°C (41°F) and +40°C (104°F).

2. The equipment will operate correctly within a relative humidity environment at 50%RH, +40°C (104°F). Higher RH may

be allowed at lower temperatures. Measures shall be taken by the Purchaser to avoid the harmful effects of occasional

condensation.

3. The equipment will operate correctly up to 2000m (6,560ft) above mean sea level.

4. The equipment will operate in a normal office type Pollution Degree 2 environment.

5. The mains supplies in this equipment are designed to work at +/-10% voltage fluctuation of the marked rating.

MAINTENANCE:

WARNING: Motor laminations are live. Turn electrical power supply

off before doing any maintenance or service to dryer. Electrical power

supply must be off unless dryer cover is secured.

1. Turn electrical power supply on.

2. Position hands under air outlet, within 100mm (4'') of air outlet

Form No. 38030-369 Issued 7/29/21

Figure 4

To remove dryer cover, remove two screws

from the bottom of the Dryer and two from

the sides, as shown in Figure 4.

and the 208-240 Volt wires to terminals

Printed in U.S.A.