Euro-Grille COKBBQEUGABR8 사용자 설명서 - 페이지 5
{카테고리_이름} Euro-Grille COKBBQEUGABR8에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Euro-Grille COKBBQEUGABR8 18 페이지.
While igniting main burner and infrared rear burner, please make sure the lid for main burner is in open situation
While igniting side burner, please make sure the lid for side burner is in open situation
While cooking with the hood closed and with all the burners on, please make sure all these burners in LOW flame
position.
CLEANING AND CARE
All cleaning and maintenance should be carried out when the barbecue is cool and with the fuel supply turned OFF at
the gas cylinder after each time use.
DO NOT mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at
the factory (and should NEVER be painted). Apply a strong solution of detergent and water or use a grill
cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry.
DO NOT apply a caustic grill / oven cleaner to painted surfaces.
DO NOT use abrasive or flammable cleaners, as it will damage the parts of the product and may start a fire.
Stainless steel surfaces: Stainless steel would get rust if not maintain well. To maintain your grill's high quality
appearance, wash with mild detergent and warm soapy water and wipe dry with a soft nonabrasive cloth after each
use.
Cooking grid: Use a mild soapy water solution. Non‐abrasive scouring power can be used on stubborn stains then
rinse with water.
Cleaning the burner assembly
Follow these instructions to clean parts of burner
assembly or if you have trouble igniting grill.
1. Turn gas off at control knobs and LP Tank.
2. Remove cooking grates, grease tray and grease cup.
3. Remove screw at end of burner using a screwdriver.
4. Carefully lift each burner up and away from valve openings.
5. Wire brush entire outer surface of burner to remove food
residue and dirt.
6. Clean any blocked ports with a stiff wire such as an open paper clip.
7. Check burner for damage, due to normal wear and corrosion some
holes may become enlarged. If any large cracks or holes are found
replace burner.
8. Carefully refit burners.
9. Replace screw at the end of burner.
10. Replace grease tray and cooking grates.
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall the
burner, check to ensure that the Gas valve orifices are correctly positioned and secured inside the burner inlet.
5