Euro-Grille COKBBQEUGABR8 User Manual - Page 5

Browse online or download pdf User Manual for Grill Euro-Grille COKBBQEUGABR8. Euro-Grille COKBBQEUGABR8 18 pages.

Print Page

While igniting main burner and infrared rear burner, please make sure the lid for main burner is in open situation

While igniting side burner, please make sure the lid for side burner is in open situation

While cooking with the hood closed and with all the burners on, please make sure all these burners in LOW flame

position.

CLEANING AND CARE

All cleaning and maintenance should be carried out when the barbecue is cool and with the fuel supply turned OFF at

the gas cylinder after each time use.

DO NOT mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at

the factory (and should NEVER be painted). Apply a strong solution of detergent and water or use a grill

cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry.

DO NOT apply a caustic grill / oven cleaner to painted surfaces.

DO NOT use abrasive or flammable cleaners, as it will damage the parts of the product and may start a fire.

Stainless steel surfaces: Stainless steel would get rust if not maintain well. To maintain your grill's high quality

appearance, wash with mild detergent and warm soapy water and wipe dry with a soft nonabrasive cloth after each

use.

Cooking grid: Use a mild soapy water solution. Non‐abrasive scouring power can be used on stubborn stains then

rinse with water.

Cleaning the burner assembly

Follow these instructions to clean parts of burner

assembly or if you have trouble igniting grill.

1. Turn gas off at control knobs and LP Tank.

2. Remove cooking grates, grease tray and grease cup.

3. Remove screw at end of burner using a screwdriver.

4. Carefully lift each burner up and away from valve openings.

5. Wire brush entire outer surface of burner to remove food

residue and dirt.

6. Clean any blocked ports with a stiff wire such as an open paper clip.

7. Check burner for damage, due to normal wear and corrosion some

holes may become enlarged. If any large cracks or holes are found

replace burner.

8. Carefully refit burners.

9. Replace screw at the end of burner.

10. Replace grease tray and cooking grates.

Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall the

burner, check to ensure that the Gas valve orifices are correctly positioned and secured inside the burner inlet.