Canon AE-1 설치 절차 매뉴얼 - 페이지 47
{카테고리_이름} Canon AE-1에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon AE-1 48 페이지.
Canon AE-1에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 사용 설명서 (22 페이지), 매뉴얼 (42 페이지), 매뉴얼 (12 페이지), 사용 설명서 (22 페이지)
4.2.2
Installation after Checks/
Adjustments
<Finisher-AE 1 >
1) If you have removed the auxiliary ring, mount the
rear left foot cover, and adjust the auxiliary rail to
suit the needs of the user, and fix it in place using
four screws.
2) Mount the front cover to the finisher using three
screws.
3) Mount the lower front extension cover [ l ] using a
screw [2] (RS tightening; M3 x 8). Mount the front
foot cover [3] using a screw [4] (RS tightening; M3
x 8).
4) Connect the finisher and the host machine using an
interface cable [I].
<Saddle Finisher-AE2>
1) Remove the punch lower front cover and the punch
rear cover (three screws), and remove the stepped
screw at the front and the rear; then, detach the
puncher unit and the host machine.
2) Open the front cover.
3) Mount the front foot cover [l] using a screw [2] (RS
tightening; M3 x 8).
4) Mount the lower front extension cover [3] using a
screw [4] (RS tightening: M3 x 8) and another
screw [5] (self-tapping; M4 x 12).
5) Close the front cover.
6) Mount the caster cover [6] using a screw [7] (RS
tightening: M3 x 8).
7) Mount the rear foot cover [8] using a screw [9]
(self-tapping; M4 x 12).