Barnant Company PK15 운영 매뉴얼 - 페이지 9

{카테고리_이름} Barnant Company PK15에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Barnant Company PK15 13 페이지. Barnant/ponndorf hose pumps

4) The hose comes out of the pump

automatically.

7) The rotor pulls in the hose automatically

as it rotates. Stop the motor immediately

as soon as the end of the hose juts out of

the casing approximately 40 mm. Unplug

the power.

WARNINGS:

Keep hair, gloves, loose clothing, jewelry, and fingers away from openings and moving parts.

The casing cover must be in place, and hands must not be put into the pump casing, unless

the drive is stopped and the power is disconnected.

Remove

Screws

5) Stop the motor and disconnect the

power. Unscrew and remove the casing

cover from the pump. Clean the casing

inside and install the cover again.

5-10mm

8) Put the clamping ring onto the hose as

shown above. Approximately 5 to 10

mm of the hose should jut out of the

clamping ring.

10) Start the motor once

again briefly until the

hose juts out of the

other opening

approximately 40

mm. Stop and

unplug the motor,

and install the

connecting socket

as described in the

previous steps.

Barnant/Ponndorf

6) Grease the new hose with Ponndorf

special lubricant. Start motor and

insert hose into the casing opening.

9) Put the connecting socket into the hose

and tighten it by tightening the screws.

Take care that the socket is inserted in

the hose up to the flange.