14POINT7 SLC DIY 2 조립 설명서 - 페이지 7

{카테고리_이름} 14POINT7 SLC DIY 2에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 14POINT7 SLC DIY 2 7 페이지.

P a g e

| 7

Mounting PCB into the Case

JP5

Mount the Display unit, Display panel, and SLC DIY 2 PCB into the case and secure using screws.

Check to make sure the

The distance from the hole in the display panel to the top

metal screws are not touching any component on the PCB.

and bottom edge is not perfectly symmetric, try installing the panel both ways and see which gives you the best fit. You

may need to tighten or loosen the screws to get the perfect fit between the button and the hole in the faceplate.

Install the jumpers on JP5 as in the above picture. The jumpers do not matter at this point, but just install them now so

you do not lose them. The Jumpers select between accelerometer and analog 0-5[v] input for datalogging, see section

1.6 of the SLC DIY 2 User Manual for more information.

Finally, secure the top of the enclosure to the bottom using the supplied screws.

There is no backplate for SLC DIY 2.