Domus FRESCO-52 설치 매뉴얼 - 페이지 14

{카테고리_이름} Domus FRESCO-52에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Domus FRESCO-52 19 페이지.

Domus FRESCO-52 설치 매뉴얼
Installation Manual
Date: November 18, 2022 10:32 am

General Maintenance

Changing Remote Batteries:
- Batteries used in Handsets will weaken over time and should be replaced every 6 months.
Batteries removed from the handset should be disposed of properly and kept out of reach of children.
*Before maintenance ensure fan is switched off at the isolation switch or circuit breaker *
Cleaning the Motor Housings:
- Motor housings should be cleaned every 3 to 4 months to avoid build up of dust. Dust will
attract moisture and condensation leading to corrosion. Use a soft, damp (not wet) cloth to remove dust. Use only water and mild
detergent. Spray cleaners may damage coatings.
Cleaning the Blades:
- Use a soft damp cloth to remove dirt from blades. Always dry blades after cleaning. Blades should not be
left damp or wet as this will damage blade finish or cause corrosion. Use only water and mild detergent. Spray cleaners may damage
coatings.
Always use soft cloths to clean blades and motor housings to avoid scratching painted and plated finishes. Ideally your fan should be
cleaned every 3 to 4 months.
If removing blades for cleaning then do so for each fan separately, do not mix blades from different fans as this can upset the balance
of the fan. Put blades back in the position they came from.
Normal Wear and Tear: - Please note that a ceiling fan travels an enormous distance in the course of its normal operation. Air is
abrasive and suspended dust, high humidity and other contamination will cause wear and tear of surfaces.
The use of fans under roofed decks and pergolas next to swimming pools and in coastal areas will require increased maintenance due
to the presence of chlorides (either as common air borne salt spray or from compounds in pool chemicals)
The temperatures attained in the peak of a pitched deck or veranda roof can easily exceed 60-70°C and especially when coupled
with chlorides this will increase maintenance requirements. Even indoors in coastal areas the influx of warm, sea air can accelerate the
surface corrosion of metal parts. This can still happen a great many kilometres from the sea.
When humidity is high and temperature drops moisture condenses on metal surfaces including ceiling fans. The layer of moisture can
be almost microscopic but it will affect the surface by depositing a tiny layer of dissolved salts or airborne acidic compounds and thus
eventually leading to corrosion if the product is not properly and regularly cleaned. This applies equally to indoor and outdoor fans.
Some colour discoloration on ABS polymer body and blade will occur over time.
LACK OF MAINTENANCE LEADING TO SURFACE CORROSION
OR SIMILAR DAMAGE IS NOT COVERED BY WARRANTY.
POWER OUTLETS OR FIXED WIRING MUST BE INSTALLED BY A LICENSED ELECTRICIAN
To protect your customer's WARRANTY please READ PAGE 2 of this booklet prior to the installation of this product.
14