Domus FRESCO-52 Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Вентилятор Domus FRESCO-52. Domus FRESCO-52 19 сторінок.

Installation Manual

Date: November 18, 2022 10:32 am

General Maintenance

Changing Remote Batteries:

- Batteries used in Handsets will weaken over time and should be replaced every 6 months.

Batteries removed from the handset should be disposed of properly and kept out of reach of children.

*Before maintenance ensure fan is switched off at the isolation switch or circuit breaker *

Cleaning the Motor Housings:

- Motor housings should be cleaned every 3 to 4 months to avoid build up of dust. Dust will

attract moisture and condensation leading to corrosion. Use a soft, damp (not wet) cloth to remove dust. Use only water and mild

detergent. Spray cleaners may damage coatings.

Cleaning the Blades:

- Use a soft damp cloth to remove dirt from blades. Always dry blades after cleaning. Blades should not be

left damp or wet as this will damage blade finish or cause corrosion. Use only water and mild detergent. Spray cleaners may damage

coatings.

Always use soft cloths to clean blades and motor housings to avoid scratching painted and plated finishes. Ideally your fan should be

cleaned every 3 to 4 months.

If removing blades for cleaning then do so for each fan separately, do not mix blades from different fans as this can upset the balance

of the fan. Put blades back in the position they came from.

Normal Wear and Tear: - Please note that a ceiling fan travels an enormous distance in the course of its normal operation. Air is

abrasive and suspended dust, high humidity and other contamination will cause wear and tear of surfaces.

The use of fans under roofed decks and pergolas next to swimming pools and in coastal areas will require increased maintenance due

to the presence of chlorides (either as common air borne salt spray or from compounds in pool chemicals)

The temperatures attained in the peak of a pitched deck or veranda roof can easily exceed 60-70°C and especially when coupled

with chlorides this will increase maintenance requirements. Even indoors in coastal areas the influx of warm, sea air can accelerate the

surface corrosion of metal parts. This can still happen a great many kilometres from the sea.

When humidity is high and temperature drops moisture condenses on metal surfaces including ceiling fans. The layer of moisture can

be almost microscopic but it will affect the surface by depositing a tiny layer of dissolved salts or airborne acidic compounds and thus

eventually leading to corrosion if the product is not properly and regularly cleaned. This applies equally to indoor and outdoor fans.

Some colour discoloration on ABS polymer body and blade will occur over time.

LACK OF MAINTENANCE LEADING TO SURFACE CORROSION

OR SIMILAR DAMAGE IS NOT COVERED BY WARRANTY.

POWER OUTLETS OR FIXED WIRING MUST BE INSTALLED BY A LICENSED ELECTRICIAN

To protect your customer's WARRANTY please READ PAGE 2 of this booklet prior to the installation of this product.