American Standard Portsmouth 9210.030 조립/설치 지침 - 페이지 2

{카테고리_이름} American Standard Portsmouth 9210.030에 대한 조립/설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Portsmouth 9210.030 14 페이지. 30" vanity

VANITY INSTALLATION

Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).

Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 31" up from

the floor (see Figure 1).

Rough in supply lines and waste per rough-in dimensions.

The molding needs to be notched to seat the vanity flush against the wall.

Move the vanity into place and level with the adjustable glides on the bottom of the feet.

The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.

Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 1"

down from the top of the table (see Figure 2).

Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

FIGURE 1

FIGURE 2

C/L of 2 x 6

Reinforcement

31"

(787mm)

Finished

Floor

21-1/2"

(546mm)

33-1/2"

(850mm)

ADJUSTABLE

LEVELLERS

(under each

foot)

REAR STRINGER WITH

ANCHORING HOLES TO

SECURE VANITY TO WALL

(76mm)

- 2 -

ANCHORING HOLES

IN REAR STRINGER

[NOT SHOWN]

77 0 0 11 -1 0 0 Re v.C