American Standard Portsmouth 9210.030 Instrukcja montażu/instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu/instalacji dla Wyposażenie wnętrz American Standard Portsmouth 9210.030. American Standard Portsmouth 9210.030 14 stron. 30" vanity
Drukuj stronę
VANITY INSTALLATION
Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).
Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 31" up from
the floor (see Figure 1).
Rough in supply lines and waste per rough-in dimensions.
The molding needs to be notched to seat the vanity flush against the wall.
Move the vanity into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.
Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 1"
down from the top of the table (see Figure 2).
Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).
Continue with installation appropriate for top and sink options chosen.
FIGURE 1
FIGURE 2
C/L of 2 x 6
Reinforcement
31"
(787mm)
Finished
Floor
21-1/2"
(546mm)
33-1/2"
(850mm)
ADJUSTABLE
LEVELLERS
(under each
foot)
REAR STRINGER WITH
ANCHORING HOLES TO
SECURE VANITY TO WALL
3"
(76mm)
- 2 -
ANCHORING HOLES
IN REAR STRINGER
[NOT SHOWN]
77 0 0 11 -1 0 0 Re v.C