Domyos VE 570 사용 설명서 - 페이지 13

{카테고리_이름} Domyos VE 570에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Domyos VE 570 19 페이지.
Domyos VE 570에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 사용 설명서 (18 페이지)

페이지 인쇄

1. Exploded View

Warning: You need to get off the elliptical bike before moving it.

Stand facing the front of the bike, hold the handlebar and pull the bike towards you. Your bike now rests on the castors and you can move

it. When you have ﬁ nished moving it, hold on to it until the back feet are back on the ground.

Warning: You need to get off the elliptical bike before levelling it.

In the event that the product becomes unstable during use, turn one of the level correctors until it is stable

again.

According to EN deﬁ nition, this product is a «speed independent product». You can adjust the braking torque

not only through the pedalling frequency, but also by choosing the resistance level manually (by turning

the torque controller button on non-motorized products, by pressing the up/down buttons on motorized products).

Nevertheless, if you keep the same resistance level, the braking torque will increase/decrease as your pedalling

frequency increases/decreases.

SETTING THE GRADIENT

You can set the gradient of your VE 570 by setting the height of the rear

leg.

There are three preset positions:

Low position = 0 degrees

You make equal demands on your upper and lower body.

Intermediate position = 5 degrees

You make more demands on your upper body while also exercising

your lower body.

High position = 10 degrees.

You make great demands on your upper body while also exercising

your lower body.

To change the gradient of your bike:

1 - Lowering your bike

2 - Stand behind your bike.

3 - To adjust the height, unscrew and pull out

the pin on the tube on the rear leg.

Set the gradient and reinsert the pin in the rear tube,

screwing it back in fully.

WARNING :

Ensure that you put the button back in place in the tube on the rear leg

and screw it back in tightly.

Never exceed the maximum height of the rear leg tube.

SETTING PEDAL POSITION

Pedal position can be set during assembly.

There are three setting positions:

Forward: Closest to the handlebars

Central

Rear: Furthest from the handlebars

The optimal set position is the central position.

However, to meet performance objectives and to best adapt the bike

to your body shape, setting the position will optimise your position

on your elliptical bike.

The forward position is especially suited to people less than 1.75m tall,

while the rear position is especially suited to people over 1.85m tall.

M O V IN G Y OUR P RO DU C T

ADJU S T M EN T S

LEVELLING THE BIKE

ADJUSTING THE RESISTANCE