Domyos VE 570 Operating Instructions Manual - Page 13
Browse online or download pdf Operating Instructions Manual for Fitness Equipment Domyos VE 570. Domyos VE 570 19 pages.
Also for Domyos VE 570: Operating Instructions Manual (16 pages), Operating Instructions Manual (18 pages)
Print Page
E
N
Warning: You need to get off the elliptical bike before moving it.
Stand facing the front of the bike, hold the handlebar and pull the bike towards you. Your bike now rests on the castors and you can move
it. When you have fi nished moving it, hold on to it until the back feet are back on the ground.
1
1
Warning: You need to get off the elliptical bike before levelling it.
In the event that the product becomes unstable during use, turn one of the level correctors until it is stable
again.
2
According to EN defi nition, this product is a «speed independent product». You can adjust the braking torque
not only through the pedalling frequency, but also by choosing the resistance level manually (by turning
the torque controller button on non-motorized products, by pressing the up/down buttons on motorized products).
Nevertheless, if you keep the same resistance level, the braking torque will increase/decrease as your pedalling
frequency increases/decreases.
3
SETTING THE GRADIENT
You can set the gradient of your VE 570 by setting the height of the rear
leg.
There are three preset positions:
Low position = 0 degrees
You make equal demands on your upper and lower body.
Intermediate position = 5 degrees
You make more demands on your upper body while also exercising
your lower body.
High position = 10 degrees.
You make great demands on your upper body while also exercising
your lower body.
To change the gradient of your bike:
1 - Lowering your bike
2 - Stand behind your bike.
3 - To adjust the height, unscrew and pull out
the pin on the tube on the rear leg.
Set the gradient and reinsert the pin in the rear tube,
screwing it back in fully.
WARNING :
Ensure that you put the button back in place in the tube on the rear leg
and screw it back in tightly.
Never exceed the maximum height of the rear leg tube.
4
SETTING PEDAL POSITION
Pedal position can be set during assembly.
There are three setting positions:
Forward: Closest to the handlebars
Central
Rear: Furthest from the handlebars
The optimal set position is the central position.
However, to meet performance objectives and to best adapt the bike
to your body shape, setting the position will optimise your position
on your elliptical bike.
The forward position is especially suited to people less than 1.75m tall,
while the rear position is especially suited to people over 1.85m tall.
G
M O V IN G Y OUR P RO DU C T
ADJU S T M EN T S
LEVELLING THE BIKE
ADJUSTING THE RESISTANCE
L
I
20
S
H