D3FY SPORTS VERT3X 소유자 매뉴얼 - 페이지 7
{카테고리_이름} D3FY SPORTS VERT3X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. D3FY SPORTS VERT3X 16 페이지. .68 caliber paintball marker
페이지 인쇄MAINTAINING YOUR VERT3X
PAINTBALL MARKER
PART # AND DESCRIPTION
(X-20-B/DB/T) RECEIVER
(I-04) DELRIN BOLT
(I-05) BOLT COCKING PIN
(I-08) STRIKER
(I-09) STRIKER SPRING - (I-10) STRIKER SPRING (HIGH VELOCITY)
(I-13) STRIKER BUFFER
(I-15) VELOCITY/SPRING GUIDE
(X-15) STRIKER PLUG
QUICK CLEAN AND DISASSEMBLE
Make sure all paintballs are removed from the marker and that the air
source is detached before attempting any maintenance and/or repairs.
1. Push the Safety button to the "SAFE" position. Cock back the bolt.
Note: This will help keep the Striker (I-08) from rotating and moving
forward.
2. Pull upward on the Bolt Cocking Pin (I-05) to disconnect from the
Striker. Remove the Delrin Bolt (I-04) by sliding it out the rear of the
Receiver/Body (X-20).
3. Wipe off any dirt,debris, or paint from the Delrin Bolt using a clean
cloth. Use a squeegee or swab to clean the inside of the Receiver.
4. Insert the Delrin Bolt with the open face in first. Align the Bolt
Cocking Pin with the Striker hole and push down on the Pin to lock it
in place.
Important: Make sure to install the Delrin Bolt with the air passage hole
located in the middle of the bolt facing downwards.
Note: If the Delrin Bolt is not installed correctly, the paintball marker will
not function properly.
7. With the Bolt Cocking Pin properly installed to the Striker, push the
Safety button to the "Fire" position. The Delrin Bolt will slide forward
when you pull the trigger.
DISASSEMBLE REAR INTERNALS
1. With the Bolt in the un-cocked position, pull upward on the Bolt
Cocking Pin to disconnect the Delrin Bolt from the Striker. Remove the
Delrin Bolt by sliding it out the rear of the Receiver.
2. Remove the Striker Plug (X-15) by unscrewing it counter-clockwise.
This will allow you to remove the Striker Spring (I-09), Striker Buffer (I-13)
MAINTAINING YOUR CONQU3ST PAINTBALL MARKER (CONTINUED) Ⅰ
5