Da-Lite Contour Electrol 지침서 - 페이지 8

{카테고리_이름} Da-Lite Contour Electrol에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Contour Electrol 13 페이지. Installer friendly features
Da-Lite Contour Electrol에 대해서도 마찬가지입니다: 지침서 (9 페이지), 설치 관리자 매뉴얼 (2 페이지), 지침서 (4 페이지), 지침서 (8 페이지), 지침서 (8 페이지)

페이지 인쇄
Da-Lite Contour Electrol 지침서
CONTOUR
ELECTROL
®
®

240V Wiring DiagraM

iMportant note: The wall switch is ReQUIReD to make
any limit switch adjustments, eVeN if a third party control
system is used. Therefore, it is advised to wire the switch or
provide a 4-conductor connection that is accessible.
Blue (Common)
power input
Brown (Hot)
240VaC / 50hz
Green
240V Wiring DiagraM With optional Built-in ViDeo proJeCtor interFaCe
Caution: the proJeCtor Must Be turneD oFF
BeFore ConneCting the trigger Wires to the
proJeCtor. Failure to Do so May DaMage the
Controller.
1. Use 2-conductor 20-24 gauge wire to extend the low voltage
connection from the projector's 5 or 12-volt screen trigger
output to the length required to reach the VPI. When
extending the low voltage connection from the projector's
screen trigger output, be sure to maintain the proper polarity.
The red wire from the VPI is the "signal" and the black wire
from the VPI is the "ground".
240VAC/ 50Hz
Power Source
Front of Wall
Back of
Switch
Wall Switch
8
INSTALLATION FOR 240V SCREENS
Motor
Green
Ground to Case
NOTe: Ground–Must be
Connected to Building Ground
Brown (Hot)
Green/Yellow
(Ground)
Blue (Common)
White
Red
Black
ilt rJ-9 pin-outs
IR or Up
Ground Common
+5V
Data or Down
RJ9
RJ9
Splitter
Dry Contacts
2. Connect the wires from the VPI that are labeled "Low
Voltage Connection" to the end of the extended screen
trigger wires above.
iMportant note: The wall switch is ReQUIReD to make
any limit switch adjustments, eVeN if a third party control
system is used. Therefore, it is advised to wire the switch or
provide a 4-conductor connection that is accessible.
Black
Red
(Tab Is Facing Up)
Black
Red
Green
White
UP
UP DN
STOP
3-POSITION
SWITCH
DOWN
Front of Wall
Back of
Switch
Wall Switch
Green/Yellow (Ground)
Brown (Down)
Blue (Common)
Black (Up)
5/12 Volt Screen Trigger
on Projector
GND
+5V
RJ9