Da-Lite Large advantage electrol 지침서 - 페이지 2

{카테고리_이름} Da-Lite Large advantage electrol에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Large advantage electrol 12 페이지. Installer friendly features
Da-Lite Large advantage electrol에 대해서도 마찬가지입니다: 지침서 (12 페이지), 설치 관리자 매뉴얼 (2 페이지), 지침서 (13 페이지)

페이지 인쇄

iMPorTANT sAfeTY iNsTruCTioNs

When using your video equipment, basic safety precautions should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over,

pulled, or contact hot surfaces.

3. If an extension cord is necessary, a cord with a current

rating at least equal to that of the appliance should be

used. Cords rated for less amperage than the appliance

may overheat.

Tools required for iNsTAllATioN

#2 Phillips Screwdriver

Pre-iNsTAllATioN

1. Carefully unpack case from shipping crate.

2. Set aside the Installation Kit. Items inside will be used during

installation.

3. Make sure to recheck measurement of case for proper

installation clearance.

CAse iNsTAllATioN

1. The case provides multiple attachment points for bolts,

cables, or threaded rod. Page 4 shows threaded rod installed.

The variable position-mounting bracket may be located

anywhere along the length of the case. It is recommended to

keep the brackets spaced evenly enough to distribute the

weight of the screen. One mounting bracket is required for

every 4' of case length.

2. Tighten bolts until trim flange is flush with ceiling.

NOTE: For proper operation, screen assembly must be level

after installation.

3. Remove 2 screws to open junction box. Install electrical

connections that apply to your unit. Make sure to review the

wiring diagram for proper hook up. Replace junction box

cover and secure with 2 screws.

NOTE: Please Note: Motor Operator Projection Screen

Models LADT, LADDT, LAD and LADD must be installed in

accordance with the requirements of the Local Building

3/4" Open Wrench

or Socket Driver

4. To reduce the risk of electric shock, do not disassemble

this appliance. Contact an authorized service dealer

when repair work is required. Incorrect reassembly can

cause electric shock when the appliance is used

subsequently.

5. The use of an accessory attachment not recommended

by the manufacturer may cause a risk of fire, electric

shock, or injury to persons.

4. Remove any protective foam from case.

5. If necessary. adjust hanger brackets with a 3/4" open wrench

or socket driver.

Codes, the Canadian Electrical Code (CEC), CAN/CSA C22.1

and the National Electric Code (NEC), NFPA 70. An

appropriate disconnect device shall be provided as part of the

building installation.

If your case was ordered in advance of the screen and roller

assembly, your installation is now complete. Continue to

step 4 if your Large Advantage Electrol was ordered as a

complete unit.

4. Carefully remove paper and tape from roller assembly

Caution! Do not use a knife or sharp objeCt

to Cut tape; you will Damage the sCreen.

pull orange string.

5. Test installation by running screen up and down a few times.

Be prepared to stop screen should any objects obstruct the

movement of the screen. To prevent damage to the motor,

the standard duty cycle is 1 minute on and 3 minutes off.