Da-Lite Large advantage electrol Livro de instruções - Página 2
Procurar online ou descarregar pdf Livro de instruções para Ecrã de projeção Da-Lite Large advantage electrol. Da-Lite Large advantage electrol 12 páginas. Installer friendly features
Também para Da-Lite Large advantage electrol: Livro de instruções (12 páginas), Manual do instalador (2 páginas), Livro de instruções (13 páginas)
Imprimir página
iMPorTANT sAfeTY iNsTruCTioNs
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over,
pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current
rating at least equal to that of the appliance should be
used. Cords rated for less amperage than the appliance
may overheat.
Tools required for iNsTAllATioN
#2 Phillips Screwdriver
Pre-iNsTAllATioN
1. Carefully unpack case from shipping crate.
2. Set aside the Installation Kit. Items inside will be used during
installation.
3. Make sure to recheck measurement of case for proper
installation clearance.
CAse iNsTAllATioN
1. The case provides multiple attachment points for bolts,
cables, or threaded rod. Page 4 shows threaded rod installed.
The variable position-mounting bracket may be located
anywhere along the length of the case. It is recommended to
keep the brackets spaced evenly enough to distribute the
weight of the screen. One mounting bracket is required for
every 4' of case length.
2. Tighten bolts until trim flange is flush with ceiling.
NOTE: For proper operation, screen assembly must be level
after installation.
3. Remove 2 screws to open junction box. Install electrical
connections that apply to your unit. Make sure to review the
wiring diagram for proper hook up. Replace junction box
cover and secure with 2 screws.
NOTE: Please Note: Motor Operator Projection Screen
Models LADT, LADDT, LAD and LADD must be installed in
accordance with the requirements of the Local Building
2
3/4" Open Wrench
or Socket Driver
4. To reduce the risk of electric shock, do not disassemble
this appliance. Contact an authorized service dealer
when repair work is required. Incorrect reassembly can
cause electric shock when the appliance is used
subsequently.
5. The use of an accessory attachment not recommended
by the manufacturer may cause a risk of fire, electric
shock, or injury to persons.
4. Remove any protective foam from case.
5. If necessary. adjust hanger brackets with a 3/4" open wrench
or socket driver.
Codes, the Canadian Electrical Code (CEC), CAN/CSA C22.1
and the National Electric Code (NEC), NFPA 70. An
appropriate disconnect device shall be provided as part of the
building installation.
If your case was ordered in advance of the screen and roller
assembly, your installation is now complete. Continue to
step 4 if your Large Advantage Electrol was ordered as a
complete unit.
4. Carefully remove paper and tape from roller assembly
Caution! Do not use a knife or sharp objeCt
to Cut tape; you will Damage the sCreen.
pull orange string.
5. Test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. To prevent damage to the motor,
the standard duty cycle is 1 minute on and 3 minutes off.