Da-Lite Multi Format Imager 지침서 - 페이지 2

{카테고리_이름} Da-Lite Multi Format Imager에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Multi Format Imager 20 페이지.
Da-Lite Multi Format Imager에 대해서도 마찬가지입니다: 지침서 (12 페이지)

페이지 인쇄

Important Safety Instructions

When using your video equipment, basic safety precautions should always be followed, including the following:

Read and understand all instructions before using equipment.

2. Close supervision is necessary when any appliance is used by or

near children. Do not leave appliance unattended while in use.

3. Care must be taken as burns can occur from touching hot parts.

4. Do not operate appliance if it has been dropped or damaged

until it has been examined by a qualified service technician.

Multi Format Imager Assembly

Preparation: Have ample space for this available on a flat clean surface such as a large table or floor. The work area should be larger

than the frame size. If the floor is used, clean papers should be spread to keep all dirt from the Pro-Trim surfaces.

Tools Required for Assembly: 1/8" Allen Wrench, 5/64" Allen Wrench, Carpenter's Level, Tape Measure, Electric Screw Gun, Utility Knife.

Unpackaging the Frame:

The frame will arrive in two separate cardboard boxes. One box

will be very long and will house the top and bottom pieces. The

smaller cardboard box will house the side frame pieces, hanger

hardware, assembly hardware and the wall switch.

2. To open the boxes, there is a side flap that is taped down the

length of the box. It will be labeled "Open This Side". Refer to

picture A. Carefully cut tape down the length of the box with a

utility knife and fold box open. You will have to pull hard as it is

stapled on the ends.

5. To reduce the risk of electric shock, do not immerse this

appliance in water or other liquids.

6. The use of an accessory attachment not recommended by

the manufacturer may cause risk of fire, electric shock or

injury to persons.

3. Inside each box the frame pieces will be individually paper

wrapped and taped. Remove all paper from pieces. Do not use

a utility knife to remove paper from pieces.

4. Remove all paper and styrofoam blocks from top frame

assembly after unwrapping.

Open This Side

Picture "A"

Cut Tape Here