Da-Lite Multi Format Imager 지침서 - 페이지 4

{카테고리_이름} Da-Lite Multi Format Imager에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Multi Format Imager 20 페이지.
Da-Lite Multi Format Imager에 대해서도 마찬가지입니다: 지침서 (12 페이지)

페이지 인쇄

Multi Format Imager Assembly

4. Fasten (3) #10 x .375" long button head screws through top of frame into the corner connector bracket. See Figure 5.

Tighten two set screws on flat "L" bracket to line up the front faces as shown in Figure 6.

5. Assemble bottom side of frame to left frame. The large metal L bracket will slide into the aluminum extrusion while the small

L bracket will slide into the aluminum channel. When sliding the bracket into the bottom frame assembly, guide the slat roller

carriage into the bottom aluminum guide channel. See Figure 7.

6. Route the two cable assemblies around motor bracket and plug the 3 wire male connector into the 3 wire female connector

on the motor bracket. The motor will have a gray data cable with an RJ-45 connector on the end coming out of the head of the

motor. Plug this end into the RJ-45 coupler. Tuck the RJ-45 coupler underneath motor bracket securely to prevent entanglement

as shown in Figure 9.

Figure 8

Figure 4

Figure 7

Large L

Bracket

Fasten Screws

Figure 5

Through Top Frame

Assembly Into

Connecting Bracket

Small L

Bracket

Aluminum Guide

Channel

Plug Motor Power In

Route Power

Cable Behind

Motor Bracket

Tuck Excess Wire

Underneath Motor

Bracket

Tuck RJ-45 Coupler

Underneath

Motor Bracket

Data Cable

From Motor Head

Figure 6

Tighten Set Screws

Until Front Surfaces

Are Flush

Figure 9