American Standard 1748 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} American Standard 1748에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard 1748 10 페이지. Aths with integral apron
American Standard 1748에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 및 운영 지침 매뉴얼 (16 페이지)

페이지 인쇄

Operation:

SYSTEM II WHIRLPOOL with CHROMATHERAPY

BATHING:

• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the

optional EZ-Heater, it will automatically maintain the water temperature.

• IMPORTANT: Do NOT fill the whirlpool more than 2/3 full before getting in, as it may overflow.

• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.

• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is started

Operating the system without water (dry running) for extended periods will cause pump damage and void the warranty.

OPERATING AIR MASSAGE and CHROMATHERAPY SYSTEM:

Function when in "Whirpool" mode

Function when in "Light" mode

AIR VOLUME CONTROL ADJUSTMENTS:

with the water. Rotate the air volume control counterclockwise for more turbulence, and clockwise for less.

FLOW JET VOLUME ADJUSTMENTS:

the nozzle counterclockwise for vigorous and clockwise for soft.

751733-100 Rev. H

Select "Whirlpool" mode

Pump On/Off

Select "Light" mode

Lights On/Off

WHIRLPOOL CONTROL:

Press this button to turn pump on and enter "Whirlpool" mode (button will light).

Once in "Whirlpool" mode, pressing button again will turn pump off.

LIGHTS CONTROL:

Press this button to turn lights on and enter "Light" mode (button will light).

Once in "Light" mode, pressing button again will turn lights off.

UP:

In "Whirlpool" mode - Press this button to increase to the next higher pump speed.

In "Light" mode - Press this button to change "up" to the next color.

DOWN:

In "Whirlpool" mode - Press this button to decrease to the next lower pump speed.

In "Light" mode - Press this button to change "down" to the previous color.

PULSE/CYCLE FUNCTION:

In "Whirlpool" mode –

• Press this button to start the pulse function (button will light).

• Pump speed will continuously vary between high and low.

• Press again to exit pulse function (button light will go out).

In "Light" mode –

• Press this button to start the cycle function (button will light).

• Light color will continuously cycle through the spectrum.

• Press again to exit cycle function (button light will go out).

• FAVORITE COLOR – If you stop the Cycle Function on a particular color,

the system will automatically return to this color the next time it is used.

Water flow-levels can be adjusted from vigorous to soft by rotating

Pump Speed

Increase

Change "Up" to

next color

Water turbulence is determined by the amount of air mixed

Pump Speed

Pump Pulse

Decrease

Function

Change "Down"

Color Cycle

to previous color

Function