American Standard Ceratherm T050.541 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} American Standard Ceratherm T050.541에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Ceratherm T050.541 10 페이지. 3/4" classic thermostat trim kit with separate volume control
페이지 인쇄
1
1
TRIM INSTALLATION
Remove PLASTER GUARD (1).
Remove HANDLE SCREW and ADAPTER (7) from
rough valve.
Push CAPS (2 & 3) as shown onto CONTROL VALVES (4).
Push ESCUTCHEON (5) onto CAPS (2 & 3) and attach
with (60mm) SCREWS (6) to valve.
Push COVER PLATE (7) onto CAPS (2 & 3) and snap
into holes in ESCUTCHEON (5) to secure.
2
INSTALL HANDLES
Install HANDLE ADAPTER (1) onto VOLUME CONTROL SPLINE (2).
Align CROSS HANDLE (3) and push onto HANDLE ADAPTER (1).
Install HANDLE SCREW (4) in CROSS HANDLE (3) and tighten with
flat blade screwdriver. Insert index button (5).
Align the two splines in LEVER HANDLE (6) with the knob mount
arrow (Figure 1) and push LEVER HANDLE (6) onto KNOB MOUNT (7).
Install HANDLE SCREW (8) in LEVER HANDLE (6) and tighten
with phillips screwdriver. Insert index button (9).
3
TRANSPOSED SUPPLY PIPING
OR BACK TO BACK INSTALLATION
Should the hot and cold water supply pipes have been transposed making
adjustment impossible, proceed as follows:
Shut off water supply.
Remove handle and rim. (Reverse steps 1 and 2.
Remove check stops and re-install them transposed.
Important note: RED CHECK STOP is now on the right of the mixer body and the BLUE
CHECK STOP is now on the left.
Turn the water supply back on and perform the temperature adjustment in step 2.
Assemble HANDLES and TRIM.
6
KNOB
MOUNT
TWO SPLINES
ARROW
Figure 1
7
4
7
2
3
6
1
2
1
7
6
CHECK STOP
(RED TO BLUE)
5
7
3
4
5
8
9
CHECK STOP
(BLUE TO RED)
M 9 6 8 4 1 9 R E V 1 . 1