American Standard Ceratherm T050.541 Installation Instructions Manual - Page 2
Browse online or download pdf Installation Instructions Manual for Thermostat American Standard Ceratherm T050.541. American Standard Ceratherm T050.541 10 pages. 3/4" classic thermostat trim kit with separate volume control
Print Page
1
1
TRIM INSTALLATION
Remove PLASTER GUARD (1).
Remove HANDLE SCREW and ADAPTER (7) from
rough valve.
Push CAPS (2 & 3) as shown onto CONTROL VALVES (4).
Push ESCUTCHEON (5) onto CAPS (2 & 3) and attach
with (60mm) SCREWS (6) to valve.
Push COVER PLATE (7) onto CAPS (2 & 3) and snap
into holes in ESCUTCHEON (5) to secure.
2
INSTALL HANDLES
Install HANDLE ADAPTER (1) onto VOLUME CONTROL SPLINE (2).
Align CROSS HANDLE (3) and push onto HANDLE ADAPTER (1).
Install HANDLE SCREW (4) in CROSS HANDLE (3) and tighten with
flat blade screwdriver. Insert index button (5).
Align the two splines in LEVER HANDLE (6) with the knob mount
arrow (Figure 1) and push LEVER HANDLE (6) onto KNOB MOUNT (7).
Install HANDLE SCREW (8) in LEVER HANDLE (6) and tighten
with phillips screwdriver. Insert index button (9).
3
TRANSPOSED SUPPLY PIPING
OR BACK TO BACK INSTALLATION
Should the hot and cold water supply pipes have been transposed making
adjustment impossible, proceed as follows:
Shut off water supply.
Remove handle and rim. (Reverse steps 1 and 2.
Remove check stops and re-install them transposed.
Important note: RED CHECK STOP is now on the right of the mixer body and the BLUE
CHECK STOP is now on the left.
Turn the water supply back on and perform the temperature adjustment in step 2.
Assemble HANDLES and TRIM.
6
KNOB
MOUNT
TWO SPLINES
ARROW
Figure 1
7
4
7
2
3
6
1
2
1
7
6
CHECK STOP
(RED TO BLUE)
5
7
3
4
5
8
9
CHECK STOP
(BLUE TO RED)
M 9 6 8 4 1 9 R E V 1 . 1