Ekinex EK-FF1-TP 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Ekinex EK-FF1-TP에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ekinex EK-FF1-TP 4 페이지. Binary output 16-fold / blind actuator 8-fold

페이지 인쇄

the programming LED is turned on;

• download into the device the physical address and the

configuration with the ETS

At the end of the download the operation of the device

automatically returns to normal mode; in this mode the

programming LED is turned off. Now the bus device is

programmed and ready for use.

Note. The configuration and commissioning of KNX

devices require specialized skills. To acquire these

skills, you should attend the workshops at KNX cer-

tified training centers.

Dimensions [mm]

144

EK-FF1-TP

16xD.O. 16(10)A/230Vac

50/60 Hz

8xBlind 16(10)A/230Vac

50/60 Hz

230V~ 50/60Hz

bus KNX

Marks

• KNX

• CE: the device complies with the Low Voltage Directi-

ve (2014/35/UE) and the Electromagnetic Compatibili-

ty Directive (2014/30/UE). Tests carried out according

to EN 50491-2:2010, EN 50491-3:2009, EN 50491-4-

1:2012, EN 50491-5-1:2010, EN 50491-5-2:2010, EN

50428:2005 +A1:2007 + A2:2009

Maintenance

The device is maintenance-free. To clean use a dry cloth.

It must be avoided the use of solvents or other aggressive

substances.

Disposal

At the end of its useful life the product

described in this datasheet is classified

as waste from electronic equipment in

accordance with the European Direc-

tive 2012/19/UE (WEEE recast), and

cannot be disposed together with the

municipal undifferentiated solid waste.

Warning! Incorrect disposal of this product may

cause serious damage to the environment and hu-

man health. Please be informed about the correct

disposal procedures for waste collecting and pro-

cessing provided by local authorities.

Warnings

• Installation, electrical connection, configuration and

commissioning of the device can only be carried out by

qualified personnel in compliance with the applicable

technical standards and laws of the respective countri-

program.

• The use of the device in security applications is not al-

lowed.The device may however be used for auxiliary

signaling functions

• Opening the housing of the device causes the imme-

diate end of the warranty period

• In case of tampering, the compliance with the essential

requirements of the applicable directives, for which the

device has been certified, is no longer guaranteed

• ekinex

KNX defective devices must be returned to the

manufacturer at the following address: EKINEX S.p.A.

Via Novara 37, I-28010 Vaprio d'Agogna (NO) Italy

Other information

• This datasheet is aimed at installers, system integra-

tors and planners

• For further information on the product, please contact

the ekinex

technical support at the e-mail address:

[email protected] or visit the website www.ekinex.

com

• KNX

and ETS

are registered trademarks of KNX As-

sociation cvba, Brussels

documentation without notice.