Astonica 50105605 사용 설명서 - 페이지 2

{카테고리_이름} Astonica 50105605에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50105605 2 페이지. Samoa cushion cast curl design hi back dining chair

페이지 인쇄

PARTS & HARDWARE LIST

PART #

Chair Back

Seat

Left

Leg/Arm

Right

Leg/Arm

M8 Studs

Bolts

Flat Washer

Lock Washers

Hex Nuts

Parts Detail

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-424-3354.

NOTE: This product is intended for residential, non-commercial use.

DESCRIPTION

QUANTITY

Install Studs to Left and Right Leg/Arms

(See Figure 1)

1. Install 2 threaded M8 Studs (E) into Left

Leg/Arm (C) with slotted end of stud

pointing outwards.

2. Repeat Step 1 with the Right Leg/Arm (D).

Attach Seat to Right and Left Leg/Arm

of Chair

(See Figure 2)

1. Slide the Seat (B) onto studs in the Right

Leg/Arm through the bolt holes in mounting

tabs located on the side of the Seat (B).

Secure the Seat to the studs using Flat

Washer (G) first, then Lock washer (H) and

Hex Nut (I). Finger tighten the Hex Nuts (I).

Do not over tighten.

2. Repeat Step 1 with the Left Leg/Arm (C).

Attach Back to Seat and Leg/Arm Assembly

(See Figure 3)

1. Position the Chair Back (A) between the

Left (C) and Right (D) Leg/Arms at the rear

of the seat. Place Lock Washers (H) onto

the M8 Bolts (F) first, and then place Flat

Washers (G) onto the M8 Bolts. Thread the

M8 Bolts through the 4 holes located inside

of the Chair Back near the bottom and into

the 4 holes inside the Leg/Arm assembly.

Tighten the M8 Bolts until the bolt is seated

securely in the Leg/Arms with an open end

wrench. Do not force the bolts to turn . This

will strip the threads.

2. Tighten the Hex Nuts (I) on the studs under

the seat.

ASSEMBLY INSTRUCTIONS

Figure 1

Figure 2

Figure 3