AmeriGlide RUBEX 설치 매뉴얼 - 페이지 13

{카테고리_이름} AmeriGlide RUBEX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AmeriGlide RUBEX 16 페이지.
AmeriGlide RUBEX에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

11819 P/N: 16169 Rev D

INSTALLING THE SEAT

STEP 1: Open the seat box and remove the seat and two call

controls from the box. Set the call controls aside.

STEP 2: Remove the four screws from the top of the unit. Set the

screws / washers aside.

Caution!

Be careful not to drop screws / washers into unit while removing.

STEP 3: Set seat on top of unit chassis. Tip seat sideways

and locate seat control wire. Plug into the unit seat control

wire. Plugs can only go together one way.

STEP 4: Lower the seat to the unit chassis. Screw in place

with four screws and lock washers previously set aside. Pull

up on swivel arm to rotate the seat to gain access to all 4

holes.

STEP 5: If the seat is not level, then you will need to adjust

the seat leveling.

STEP 6: There are 4 hex head screws that hold the seat level.

There are two on the footrest side of the chassis, and two on

the back side. Loosen all four a couple of turns (they cannot

be taken out).

STEP 7: Firmly level the seat by pushing up on one arm and

down on the other arm, until the seat is level.

STEP 8: Re-tighten the 4 hex head screws.

NOTE: While these screws are primarily used to adjust the

level of the seat, they also serve to loosen the chassis so

it realigns itself when needed.

The unit is designed so it will not run unless the seat

is facing forward and the swivel lock is in place.

Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648

13 //