AmeriGlide RUBEX Посібник з монтажу - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з монтажу для Підйомні системи AmeriGlide RUBEX. AmeriGlide RUBEX 16 сторінок.
Також для AmeriGlide RUBEX: Посібник користувача (8 сторінок)
Друкувати сторінку11819 P/N: 16169 Rev D
INSTALLING THE SEAT
STEP 1: Open the seat box and remove the seat and two call
controls from the box. Set the call controls aside.
STEP 2: Remove the four screws from the top of the unit. Set the
screws / washers aside.
Caution!
Be careful not to drop screws / washers into unit while removing.
STEP 3: Set seat on top of unit chassis. Tip seat sideways
and locate seat control wire. Plug into the unit seat control
wire. Plugs can only go together one way.
STEP 4: Lower the seat to the unit chassis. Screw in place
with four screws and lock washers previously set aside. Pull
up on swivel arm to rotate the seat to gain access to all 4
holes.
STEP 5: If the seat is not level, then you will need to adjust
the seat leveling.
STEP 6: There are 4 hex head screws that hold the seat level.
There are two on the footrest side of the chassis, and two on
the back side. Loosen all four a couple of turns (they cannot
be taken out).
STEP 7: Firmly level the seat by pushing up on one arm and
down on the other arm, until the seat is level.
STEP 8: Re-tighten the 4 hex head screws.
NOTE: While these screws are primarily used to adjust the
level of the seat, they also serve to loosen the chassis so
it realigns itself when needed.
The unit is designed so it will not run unless the seat
is facing forward and the swivel lock is in place.
Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648
13 //
16