Door Knox VDP301 사용자 설명서 - 페이지 4

{카테고리_이름} Door Knox VDP301에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Door Knox VDP301 13 페이지. Wireless external door entry kit

Safety Instruction

1. Do not install the equipment in high temperature or high humidity environment.

2. Keep the unit away from televisions or intercom equipment that may cause interference.

3. Do not touch the screen with wet hands.

4. Always clean the equipment with a dry soft cloth. Do not use detergent, thinners,

volatile or corrosive liquids.

5. Keep the camera unit away from direct sunlight as this can affect the camera CCD.

6. Sometimes vehicle interference may cause blurred pictures.

7. Building walls or structures separating the camera and monitor will reduce wirefree

transmission strength and or distance.

System Installation

VDP404 Monitor

1. Remove battery cover, fit Lithium battery and replace cover. The plug top has a

USB type power connector and connect it to the monitor.

2. Plug the power adapter into a 100 ~ 240vAC 0.35A power source and open the

bracket stand on the back of the monitor. The plugtop charger is 5vDC 1A and the

battery is a Lithium 3.7v DC battery.

NOTE: The same battery is fitted in the camera unit that also runs off a 12vDC power adapter.

You can charge the battery taken from the camera unit, in the monitor, using the USB type plugtop.

Monitor Standby Time: 3 days

Monitor Run Time: 2 hours

VDP301 Camera Unit

1. Connect the battery and fit the camera

into the rain shield. Ensure battery is

connected to correct polarity. The camera

unit can run directly from the battery or

be powered using the 100 ~ 240vAC 0.8A

power adapter that outputs 12vDC at 1.1A.

This can be used to charge the Lithium

3.7vDC battery or you can charge the battery

in the monitor using the USB plugtop.

Note the camera only works in the Rain Shield

Camera Standby Time: 31 days

Email:

Note that there is a magnet located in the rain

shield that will trigger the alarm in the camera

and on the monitor if the camera is removed

when power or battery is connected.

Camera Run Time: 2.5 hours

Doc XVDP400

Last Revised: 13/07/2017