astra telematics AT211 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} astra telematics AT211에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. astra telematics AT211 5 페이지.

Fit the CB211 cable to the AT211 system connector

a. The CB211 cable has a DB9 female RS232 connector and 4 way Molex Microfit

connector for power and ignition.

b. Connect the DB9 serial connector to your PC COM port or USB-RS232 adapter

c. If you have fitted a battery you should now see text scrolling continuously from the

AT211 to TeraTerm

d. Connect the power as outlined below

CB211 cable

CB001 cable (3 way power & ign)

e. Connect the IGNITION wire to an ignition switched 12/24V signal (i.e. something that

only goes live when the vehicle ignition is ON

6. Configure the AT211 to Communicate with your Platform

a. Once the device is running and you can see output text scrolling in TeraTerm, you are

ready to configure the device by typing or pasting commands into the TeraTerm

window (note: these commands can be sent by SMS also).

b. Configure the AT211 mobile network operator APN settings to match your SIM, using

the commands:

$APAD,<apn-address>

$APUN,<apn-username>

$APPW,<apn-password>

example:

$APAD,internet

$APUN,web

$APPW,web

Note: if using an ASTRA SIM card, the device APN will be configured by default:

$APAD,astra

If you don't know the appropriate APN settings for the network operator you are

using, you can look them up from:

c. Configure your platform IP Address (or hostname) and port. This is the destination

that the AT211 will deliver data reports via TCP socket connections. The commands

are:

$IPAD,<ip-address-or-hostname>

$PORT,<port-number>

+VE Power

red

http://www.taniwha.org.uk/gprs.html

-VE Power

IGNITION

black

white

black

white