AMERITRON AL-82 사용 설명서 - 페이지 8

{카테고리_이름} AMERITRON AL-82에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMERITRON AL-82 16 페이지. Full power
AMERITRON AL-82에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

INTERCONNECTION
1. Connect the RF output of the exciter to the RF IN connector
on the rear of the AL-82 with 50 ohm coax. Use any good
quality 50 ohm cable long enough to connect the amplifier to
the exciter. The amplifier uses a standard SO-239 female that
will mate to a PL-259 male connector on the cable.
2. Connect the existing station antenna system to the RF OUT
connector on the rear of the AL-82 with RG-8 type coax. This
connection uses PL-259 connectors.
3. Use shielded audio type cable with standard male phono
plugs to connect to the RELAY jack on the AL-82. This jack
has positive 12V DC open circuit and supplies
100mA of current when pulled to ground.
4. Connect a short ground lead from a good earth and RF ground
to the GND terminal.
5. The 12V connection on the rear panel provides 12V DC at 100
mA maximum to operate external dial lamps or accessories such
as the ATR-15 Antenna Tuner.
6. DO NOT CONNECT THE "ALC OUT" SOCKET ON THE
AMPLIFIER TO THE "ALC" SOCKET ON THE
TRANSMITTER UNTIL INSTRUCTED TO DO SO IN THE
TUNE UP PROCEDURE. This jack provides up to 20 Volts of
negative voltage for transmitter gain control.