DoorHan FAST-750 설치 및 운영 매뉴얼 - 페이지 13

{카테고리_이름} DoorHan FAST-750에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan FAST-750 18 페이지.
DoorHan FAST-750에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (16 페이지)

7. REMOTE CONTROL PROGRAMMING

7.1. To add a remote control

1. Press and hold the «R», until «00» appears on the display. Release the button.

2. Select on the control panel the button, with the help of which you will control the operator's work, and press it twice.

3. Repeat above operations for other remote controls (maximum quantity — 20 pcs.).

4. All the remote controls will be added sequentially into the control block.

5. When the maximum quantity of remote controls is exceeded; three long beeps will sound.

7.2. Remote programming for Doorhan remote controllers

1. To press and hold the button «2» of the programmed remote control.

2. Without releasing the pressed button «2», to press and hold the button «1» of the remote control.

3. Release the buttons pressed.

4. Press the remote control button already set up.

5. On the new remote control, select a button with the help of which you will control the operator's work, and press

it twice. A beep will sound.

NOTE

It is possible to add all four control buttons into the operator.

7.3. MARKING remote control buttons DOORHAN

7.4. To erase a remote control

To delete the remote controls from the receiver memory,

press and hold down the button "R" for 10 seconds until the

long beep will sound, what means erasing a remote control

in the operator.

WARNING! If the remote control is lost, it is necessary to erase the radio codes and reprogram the remote

controls to avoid unauthorized access.