DoorHan FAST-750 Kurulum ve Kullanım Kılavuzu - Sayfa 13
Kapı Açıcı DoorHan FAST-750 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DoorHan FAST-750 18 sayfaları.
Ayrıca DoorHan FAST-750 için: Kurulum ve Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
7. REMOTE CONTROL PROGRAMMING
7.1. To add a remote control
1. Press and hold the «R», until «00» appears on the display. Release the button.
2. Select on the control panel the button, with the help of which you will control the operator's work, and press it twice.
3. Repeat above operations for other remote controls (maximum quantity — 20 pcs.).
4. All the remote controls will be added sequentially into the control block.
5. When the maximum quantity of remote controls is exceeded; three long beeps will sound.
7.2. Remote programming for Doorhan remote controllers
1. To press and hold the button «2» of the programmed remote control.
2. Without releasing the pressed button «2», to press and hold the button «1» of the remote control.
3. Release the buttons pressed.
4. Press the remote control button already set up.
5. On the new remote control, select a button with the help of which you will control the operator's work, and press
it twice. A beep will sound.
NOTE
It is possible to add all four control buttons into the operator.
7.3. MARKING remote control buttons DOORHAN
1
3
4
2
7.4. To erase a remote control
To delete the remote controls from the receiver memory,
press and hold down the button "R" for 10 seconds until the
long beep will sound, what means erasing a remote control
in the operator.
WARNING! If the remote control is lost, it is necessary to erase the radio codes and reprogram the remote
controls to avoid unauthorized access.
3
2
1
4
REMOTE CONTROL PROGRAMMING
1
2
1
2
13