DoorHan SHAFT-50 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} DoorHan SHAFT-50에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan SHAFT-50 12 페이지.
DoorHan SHAFT-50에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)

3. OPERATOR UNIT

1. Set of spanners

2. Set of slotted and cross screwdrivers

3. Set of drills for metal

WARNING! Make sure, that the door is in good working condition and the torsion springs balance the door leaf before installation. Install the

operator as described below (see par. 4.2 or 4.3).

•

Install mounting bracket on the wall using screws. The mounting bracket can be installed from the left or from the right of the operator.

•

Install the first closing ring on the door shaft.

•

Install the operator on the door shaft (make sure, that the bushing key is in proper position) and screw it to the mounting basis.

•

Install the second closing ring on the door shaft and push it close to the operator.

•

Install the first closing ring close to the operator and fix both closing rings.

Closing ring

4. Set of drills for concrete

5. Pliers

6. Hacksaw for metal

Bushing key

Operator

Closing ring

Fastening bolt

1. Release cord

2. Manual chain

3. Motor

4. Limit switches

5. Reducer housing

6. Limit switches

7. Manual drive unit

7. Electric drill

8. Tape measure (folding rule)

Closing ring

Bolt (M10)

OPERATOR UNIT

Shaft