AmeriVacS AVS-20 소유자 매뉴얼 - 페이지 4

{카테고리_이름} AmeriVacS AVS-20에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AmeriVacS AVS-20 12 페이지. Retractable nozzle vacuum sealer

Make sure the Main on/off switch is set to the "0" position. Connect your

Power Cord to the Power Receptacle on the back of the Vacuum Sealer

and to a Standard 120 Volt A.C. outlet (or to a 220-240 Volt A.C. outlet if

your unit is made for this higher voltage – See serial number tag next to

the Power Receptacle of your Sealer to confirm)

Connect the supplied push fitting-1/4" Thread adaptor to your compressed

air source. Then use the supplied ¼" tubing to connect between the fitting

on your Vacuum Sealer (labeled "AIR") and to the compressed air source.

Please be careful when adding air pressure to the Vacuum Sealer as the

bar will quickly rise. Please use clean dry air only to keep your sealer's

internal components working for years to come. The Vacuum Sealer

requires a constant air pressure between 100 to 110 psi.

SETTING THE SEAL PART OF YOUR AMERIVACS

RETRACTABLE NOZZLE VACUUM SEALER

1. Turn on your Vacuum Sealer by pressing the main On/Off (I/0) switch.

2. Set Heat Timer to four (4) seconds and Cool Timer to six (6).

3. Take one bag and fold it in half. Place your folded bag between the jaws

back enough to extend past the Pressure Bar. Placing it above, below or

to one side of the nozzle is ok.

4. Hold bag taut on the

sides close to the front of

the Pressure bar (to

avoid any wrinkles in

your seal), and keeping

fingers away from the

Sealing Jaws, press Foot

Switch long enough so

that the Pressure Bar

closes, then release; The

Nozzle will retract, the

Pressure Bar will close

tighter and the bag will

be heat sealed as indicated by the LED lights on the Heat and Cool

Timers then, the Pressure Bar will rise, releasing your bag and the nozzle

will slowly extend outward, ready for the next cycle.