DoorHan SHAFT-30 설치 및 운영 매뉴얼 - 페이지 6
{카테고리_이름} DoorHan SHAFT-30에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan SHAFT-30 12 페이지. Ip65/60 ip65
DoorHan SHAFT-30에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 매뉴얼 (12 페이지)
페이지 인쇄
4.3. INSTALLATION VIA CHAIN DRIVE
•
Additional accessories for installation (bracket, large and small sprockets, chain) are purchased separately.
Install the large sprocket on the door shaft end.
•
•
Fix the bracket on the wall according to the length of the chain using dowels.
•
Secure the operator on the bracket using 4 bolts M10. Tension the chain, having adjusted the position of the operator.
Installation variants
Direct transmission 1:1
Gear ratio 1:1.5
Operator
Manual chain
5. ADJUSTMENT OF EXTREME POSITIONS
5.1. CLOSED POSITION (RED CAM)
Coarse adjustment
•
Make sure, that the operator is fixed rigidly; close the door tightly.
•
Loosen the screw for coarse adjustment of red cam, then turn it so, that the microswitches are pushed, then tighten the
screw.
•
Open and close the door, make sure, that the red cam pushes the microswitches and DL3 indicator goes off on the control block.
Fine adjustment
Turning screw for fine adjustment, correct the closed position of the door.
•
Open and close the door, make sure, that the red cam pushes the microswitches and the door stops in the required
position.
•
Clockwise turn of the screw causes earlier actuation of the limit switch, counterclockwise turn of the screw causes later
actuation respectively.
•
Open and close the door, make sure, that the red cam pushes the microswitches and the door stops in the required
position.
6
Torque, N·m
30
45
Bracket
Cable
ADJUSTMENT OF EXTREME POSITIONS
Shaft speed, rpm
Maximum amount of shaft rotations
32
21
Door shaft
Large sprocket
Chain
Small sprocket
24
18