Canon PIXMA MP150 서비스 매뉴얼 - 페이지 7

{카테고리_이름} Canon PIXMA MP150에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MP150 26 페이지. Recycled cartridge
Canon PIXMA MP150에 대해서도 마찬가지입니다: 설정 지침 (2 페이지), 보충 설명서 (6 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (4 페이지), 설치/문제 해결 매뉴얼 (6 페이지)

페이지 인쇄

3. ERROR DISPLAY

The errors / alarms occurred in the printer is displayed as follows:

1) In Operator Call Error, the Alarm LED is lit to display an error.

(In a service mode, an error is displayed by the Alarm LED blinking.)

Service Call Error is displayed by the number of the Alarm LED blinking.

2) An error / alarm is displayed on the LCD monitor of the operation panel.

3) An alarm is displayed on the status monitor of the printer driver.

3-1.

Operator Call Error (Alarm LED Blinking in Orange)

LED display

2 times

3 times

5 times

E14

E15

15 times

E16

Alarm LED blinking

(Service mode)

No paper

(ASF)[1000]

Paper jam[1300]

No ink[1600]

The ink cartridges are

not installed[1401],

or a non-supported ink

cartridge is

installed[1485],

or the ink cartridges are

not installed

properly[1687].

Waste ink absorber

full[1700],

or platen waste ink

absorber full[1710].

The connected digital

camera / video camera

does not support

Camera Direct

Printing.[2001]

The Ink cartridges whose

destination are

wrong.[1684]

Ink cartridge is not

installed.[1682]

Ink remaining is

unknown. [1685/1686]

Error

Corrective action

(Error code)

Set paper in ASF, and

press the OK button.

Remove the jammed

paper, and press the OK

button.

Replace the ink

cartridge(s), or press the

OK button.

Check if supported ink

tank(s) is installed, and

re-install them properly,

and then close the

scanning unit.

Pressing the OK button

will clean the error, and

enable to print.

In repair,

<Replacement of Ink

absorber kit

(QY5-0149-000)>

<Replacement of Platen

waste ink absorber

QC1-6014-000)>

Disconnect the cable

from a the digital

camera/video camera,

and press the Reset

button, and then

re-connect the cable.

Check if supported ink

tank(s) is installed, and

re-install it properly, and

then close the scanning

unit.

Re-install the ink

cartridge(s) properly and

close the scanning unit.

Or Turn on/off the

machine with the ink

cartridges installed.

Install an new ink

cartridge, or press the

OK button.

* When an cartridge that

was once used

(excluding the cartridge

used just before) is

installed, this error

occurs.

(7/24)

Remarks

When selecting to press

the OK button, ink may

run out during printing.

Waste ink absorber full

warning (service call

error) may appear.

When the error is

resolved by pressing the

OK button, the function

for detecting the

remaining ink level will

be released.