DoorHan SMARTROLL 프로그래밍 지침 매뉴얼 - 페이지 10

{카테고리_이름} DoorHan SMARTROLL에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan SMARTROLL 12 페이지. Control board

2.2. TRAVEL LIMITS AND AUTOMATIC CLOSING ADJUSTMENT

1. Verify that rolling shutters are closed.

2. Press and hold the "P" button till the "Program" indicator lights up. A short beep will sound in three seconds and the

rolling shutter will start opening.

3. If you want to disable the previously configured auto-close function, briefly press and release the "P" button.

4. When the rolling shutter is fully open press the "P" button. The program will remember the operator working time, two

short beeps will sound, and the program will enter the operating mode.

5. If you need to adjust the auto-close function, then hold the "P" button pressed till the "Program" indicator goes off and a

beep sounds. The timer automatically starts.

6. Wait the required time and press the "P" button (maximum automatic closing time is 5 minutes), two short beeps will

sound, and the program will enter the operating mode.

2.3. RESET TO FACTORY SETTINGS

1. Before supplying power to the board press and hold the "P" button.

2. Switch on the control board power. "Remote" and "Program" indicators will light up.

3. After 10–12 seconds the indicators will go out, factory settings will be restored and the program will enter the operating

mode.

4. Release the "P" button.

3. REMOTE CONTROL PROGRAMMING

3.1. RECEIVER MEMORY CLEARING

Press and hold the "R" button, the "Remote" indicator will light up red. After 10 seconds a long beep will sound, the indicator

will go out and light up for one second to confirm that all control units were erased. Release the "R" button.

3.2. RECORDING OF REMOTE CONTROLS

Press and hold the "R" button for 3 seconds. A beep will sound and the "Remote" indicator will light up red. Release the "R"

button. On the remote control, press and release the button that you would like to program twice. A short beep will sound, the "R"

indicator will flash once to confirm the code has been recorded in the receiver.

If no command is given from the remote control for 10 seconds then the control board will exit control unit recording mode.

NOTES:

Now you can record multi-channel remote controls, allowing you to control opening, stopping and closing separately.

Multi-channel remote control occupies two memory cells of the receiver.

If the receiver memory is overflown then three beeps will sound and the "R" indicator will flash three times (maxi-

mum number of remote controls in the receiver memory is 60 pcs.).

To record several remote controls repeat the recording procedure for each unit.

3.3. REMOTE PROGRAMMING OF REMOTE CONTROLS

Perform steps 1–4 within a 5-seconds interval:

1. Press and hold the button 2 (see the figure on p. 11) of the programmed remote control.

2. While holding the button 2, press and hold the button 1.

3. Release all pressed buttons.

4. Press the programmed remote control button; the receiver will enter remote control programming mode (a short beep will

sound, the "Remote" indicator will light up).

5. On a new remote control press twice the button, that you wish to operate the operator. A short beep will sound, the "Re-

mote" indicator will flash once to confirm the remote control code has been recorded.

REMOTE CONTROL PROGRAMMING