DoorHan SMARTROLL 프로그래밍 지침 매뉴얼 - 페이지 9

{카테고리_이름} DoorHan SMARTROLL에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan SMARTROLL 12 페이지. Control board

페이지 인쇄

1.3. PHOTOCELLS WIRING DIAGRAM

WARNING! If no safety devices are connected to the "Stop" terminal then set a jumper between this contact and the com-

mon (GND) contact.

2. OPERATOR PROGRAMMING

2.1. CONTROL BOARD OPERATING MODES

Selection of operating mode is performed with the "P" button. Number of the "P" button clicks corresponds to the selected

operating mode number:

one press — operating mode #1;

two presses — operating mode #2;

three presses — operating mode #3.

The selected operating mode is displayed by the "Program" indicator, the number of blinks corresponds to the number of the

set mode.

Operating mode

Contact

closure

S-B-S

Open

Stop

Ph.CL

Opening of rolling shutter

Pulse pressing of the button

Press and hold the button

Pulse pressing of the button

Rolling shutter

Rolling shutter is stopped

is opening

Stop

—

Photocell-N

Rolling shutter is stopped

after opening

Closing

Stop

—

OPERATOR PROGRAMMING

Table 2.1. Control board operating modes

Closing of rolling shutter

Pulse pressing of the button

Press and hold the button

Table 2.2. Terminals operation logic

Rolling shutter

after closing

Opening

is closing

Stop

—

Closing