DoorHan PCB-SH380 프로그래밍 지침 매뉴얼 - 페이지 7
{카테고리_이름} DoorHan PCB-SH380에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SH380 8 페이지.
페이지 인쇄
2. OPERATOR PROGRAMMING
Programming of the operator is accomplished by DIP switch keys.
In order to choose the program logic of the operator install DIP switch keys to the appropriate position according to the
description pointed out below:
On
DIP3
DIP2
DIP1
WARNING! It is recommended to use pulse logic for door closing only if safety photocells are available.
DIP1 — Is in charge of automatic closing of the operator
Off
ON — Automatic closing is switched on (30 seconds)
OFF — Automatic closing is switched off
DIP2 — Is in charge of the program logic of the operator on closing
ON — Closing is accomplished by holding the button
OFF — Closing is accomplished by impulse pressing of the button
DIP3 — Is in charge of the program logic of the operator on opening
ON — Opening is accomplished by holding the button
OFF — Opening is accomplished by impulse pressing of the button
OPERATOR PROGRAMMING
7