AmeriWater SCALA2 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} AmeriWater SCALA2에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AmeriWater SCALA2 14 페이지. Booster pump

INSTALLATION & START-UP

WARNING:

The installation and operation should be in accordance with local regulations and accepted

codes of good practice.

1. Always mount the pump on the base plate with horizontal suction and discharge ports.

2. Place the pump system on solid, level foundation and secure with screws through the holes in the

base plate. Do not start the pump until it has been filled with water.

3. Unscrew the priming plug and pour minimum 0.5 gallons of water into the pump housing.

4. Screw the priming plug on again.

CAUTION:

Always tighten priming and drain plugs by hand.

5. Connect the 1 ¼" hose barb (inlet) to a water source and the 1" hose barb (outlet) to the water

system with a hose and hose clamps.

6. Open a tap or sample port to prepare the pump for venting.

7. Connect the mains supply cable of the pump to the electricity supply. When the cable is

connected, the Grundfos Eye should illuminate and the pump will start.

8. When water flows without air, close the tap or sample port.

9. Open the highest tapping point in the installation.

10. Adjust the pressure setpoint to the required pressure by means of the UP/DOWN buttons.

11. Close the tapping point. Startup has been completed

SCALA2 BOOSTER PUMP

98-2039 Rev A