DoorKing 1601-235 설치 매뉴얼 - 페이지 2
{카테고리_이름} DoorKing 1601-235에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorKing 1601-235 6 페이지.
페이지 인쇄Run Wire Harness (1601-345)
Choose which side of the operator the arm is mounted on, remove knock-out and run wire harness accordingly as shown.
Use supplied adhesive
zip tie to secure harness
to bottom of bracket.
Plug in reverse edge.
Use bottom hole on arm bracket to secure wire guard.
Install Arm Cover
IMPORTANT: Wire harness MUST
remain clear of the rotating arm and
the arm cover to avoid wire chaffing.
A r m
C o
v e r
Note for Older Covers:
See page 4.
1601-268-B-12-19
N e
a r
S i d
e
O p
t i o n
r e
W i
a r d
G u
IMPORTANT: Allow a loop in the
wire harness for rotating arm.
2
F a r
O p
K n
o c k
- O u
t
Note for Older Operators:
Wiring:
A 5/8" hole will have to be
See page 3.
drilled in the operator
cabinet approximately
where Knock-Out is
shown. Make sure 5/8"
hole is clear of all internal
components.
DO NOT operate arm with a
malfunctioning reverse edge.
S i d
e
t i o n
K n
o c k
- O u
t
IMPORTANT: Allow a loop in the
wire harness for rotating arm.