Canon PIXMA MP610 Series 서비스 매뉴얼 - 페이지 36
{카테고리_이름} Canon PIXMA MP610 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MP610 Series 45 페이지. All-in-one photo inkjet printer
Canon PIXMA MP610 Series에 대해서도 마찬가지입니다: 여기에서 시작 (2 페이지), 보충 설명서 (6 페이지), 브로셔 및 사양 (2 페이지), 빠른 시작 매뉴얼 (40 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
- 1. Table of Contents
- 1. 1 Maintenance
- 1. Adjustment, Periodic Maintenance, Periodic Replacement Parts, and Replacement Consumables by Service Engineer
- 1. Customer Maintenance
- 1. Special Tools
- 1. Serial Number Location
- 2. 2 List of Error Display / Indication
- 2. Operator Call Errors
- 2. Service Call Errors
- 2. Other Error Messages
- 2. Warnings
- 2. Troubleshooting by Symptom
- 3. 3 Repair
- 3. Notes on Service Part Replacement
- 3. Adjustment / Settings
- 3. Verification Items
<Left margin correction>
Adjust the left margin for duplex printing or printing from the cassette.
1) Duplex printing from the rear tray and cassette
In the left margin correction mode, press the Stop/Reset button 1 time, then press the ON/OFF button 1 time. Duplex printing is
performed from the rear tray and cassette.
Number of times
the Stop/Reset
button is pressed
(L)
0 times
No operation
1 time
Duplex printing from the rear tray and cassette
Return to the service mode menu selection (no writing
2 times
to the EEPROM)
From each paper source (rear tray and cassette), 2 sheets of paper are ejected. The first sheet is blank, and the left margin correction
pattern is printed on the second sheet.
<Printing sequence>
For detail, see the flowcharts below.
i. A sheet of paper feeds from the rear tray, and ejected blank (single-sided printing).
ii. A sheet of paper feeds from the rear tray. Nothing is printed on the front side, and the pattern is printed on the back side (duplex
printing).
iii. A sheet of paper feeds from the cassette, and ejected blank (single-sided printing).
iv. A sheet of paper feeds from the cassette. The pattern is printed on both sides of paper (duplex printing).
A total of 4 sheets are ejected.
After this, set the correction value to the EEPROM in the steps below.
2) Selection of the parameter mode for left margin correction
Press the Stop/Reset button the specified number of time(s) according to the parameter mode listed in the table below, then press
the ON/OFF button.
Each time the Stop/Reset button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and Power in green.
Number of times
the Stop/Reset
button is pressed
(M)
0 times
Duplex printing from the rear tray and cassette
1 time
Back side of paper fed from the rear tray
2 times
Front side of paper fed from the cassette
3 times
Back side of paper fed from the cassette
Return to the service mode menu selection (after
4 times or more
writing to the EEPROM)
Operation
Parameter mode
34 / 43