Canon PIXMA MX420 Series 네트워크 설정 문제 해결 - 페이지 8

{카테고리_이름} Canon PIXMA MX420 Series에 대한 네트워크 설정 문제 해결을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX420 Series 34 페이지. Cartridge reset
Canon PIXMA MX420 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (24 페이지), 사양 (2 페이지), 네트워크 설치 매뉴얼 (14 페이지), 네트워크 설정 매뉴얼 (9 페이지), 설정 (29 페이지), 매뉴얼 (4 페이지)

페이지 인쇄

•

When using an access point that does not support WPS, configure settings manually. For the

procedure to configure settings of the machine manually, refer to "Wireless Setup Using Easy

Setup" in the printed manual: Getting Started.

Problems during Software Installation

The Machine is Not Displayed (Detected)

Check

Check 1

For a wireless connection, make sure that you follow Check 1, 2, 3, 4, 5 and 8 of

"Connection Checklist" on page 15, then click Update (A).

For a wired connection, make sure that you follow Check 1, 2, 6, 7 and 8 of

"Connection Checklist" on page 15, then click Update (A).

Check 2

Is the machine connected to a network?

•

To confirm the connection status, press the Setup button, then using the { } [ ] and OK

buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list

or LAN setting list. Make sure that Connection is set to Active.

If the machine is not connected to a network, perform setup again by following the

procedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printed

manual: Getting Started.

•

Check Check the printer settings (B), click Next (C), then click Wireless LAN Setup

Information on the Check Printer Settings dialog box to display the access point information

stored on your computer. Refer to the information when configuring the network setting for the

machine. Wireless LAN Setup Information may not be displayed. (* Wireless connection only)