Canon PIXMA MX522 설정 매뉴얼 - 페이지 28
{카테고리_이름} Canon PIXMA MX522에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX522 31 페이지. Cartridge reset
Canon PIXMA MX522에 대해서도 마찬가지입니다: 간편한 설정 (2 페이지), 시작하기 (4 페이지), 매뉴얼 (8 페이지), 매뉴얼 (4 페이지)
페이지 인쇄
The device may not be able to connect to the network in the following cases:
If the DHCP function of the access point is inactive, enable the DHCP function or specify the IP address (IPv4 only)
of the printer and confi gure wireless connection settings again. In addition, make sure that the selected WEP key
number and entered WEP key are correct.
For details on how to check or change the settings of the access point, refer to the manual supplied with the access
point or contact its manufacturer.
To specify the IP address of the printer, follow the procedure below.
1. Press the MENU button.
2. Select Setup in the next screen, then press the OK button.
3. Select Device settings, then press the OK button.
4. Select LAN settings, then press the OK button.
5. Select Other settings, then press the OK button.
6. Select TCP/IP settings, then press the OK button.
7. Select IPv4, then press the OK button.
8. Select Yes, then press the OK button.
9. Select IP address, then press the OK button.
10. Select Manual setup, then press the OK button.
Follow the on-screen instructions to proceed with settings.
When the setup is complete, press the MENU button.
To perform Advanced setup again
1. Press the MENU button (A).
2. Use the
buttons (B) to select WLAN setup, then press the OK button.