Akva-Stabil Effect-Line 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} Akva-Stabil Effect-Line에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Akva-Stabil Effect-Line 12 페이지. Aquarium racks

Remove the protective paper from the double-sided tape.

Clean the plastic sheets carefully and mount them on the

rear of all aquariums.

Carefully move the aquariums into position. Remember

to work from your layout plan.

NB. If a pipe system is mounted, all aquariums in the

same section must be of the same type.

Position a white pad under

each corner of all aquari-

ums.

The white pad must be

ﬂush with the outside

edges of the aquarium. Pull

the aquariums forward all

the way to the front edge of

the shelving unit.

If no pipe system is mount-

ed, seal the holes with the

plugs.

Remove the nut and the

white washer from the

return pipes.

Carefully guide the return pipes behind the shelving unit.

Push the bushings up

through the holes in the

base glass of the aquari-

ums.

The rubber gasket and cap

will sit inside the aquari-

um.

There may be 2 gaskets on

certain bushings. These are

for adjustment purposes

and must be left in posi-

tion.

Mount the white washers

and screw the nuts onto the

bushings.