DoorKing 2372-800 운영 지침
{카테고리_이름} DoorKing 2372-800에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorKing 2372-800 3 페이지. Wireless dual band repeater kit
페이지 인쇄WIRELESS DUAL BAND REPEATER KIT
The wireless dual band repeater kit (DBR) extends and expands the wireless communication range between an access control system and wireless
tracker expansion board or "tracker board". It gets installed between the wireless devices that are too far or obstructed from each other to reliably
communicate with each other. It will receive a signal sent to it and repeat that signal to the next wireless device. Multiple DBRs can be used in the
same communication line of a tracker board. The signal range of a DBR is approximately 500 ft direct-line-of-sight with no signal interference.
2361 Wireless
Baseboard
TELEPHONE ENTRY SYSTEM
SP
SP
ABC
ABC
DEF
DEF
1 1
2 2
3 3
GHI
GHI
JKL
JKL
MNO
MNO
4 4
5 5
6 6
Example:
PQRS
PQRS
TUV
TUV
WXYZ
WXYZ
7 7
8 8
9 9
OPER
OPER
0 0
HOLD TO SCAN
A
OPERATING INSTRUCTIONS
The wireless baseboard
1.
Use "A to Z" Buttons to Locate
Name and Code Number on Display.
Names are In Alphabetical Order.
Z
2.
T o Call, Enter Code Number on
Keypad or Press "Call" Button. If
Line is Busy, Press "#" or "Call" to
Hang Up. Try Again.
MUST be set to:
3.
E nter on Open Display and Tone.
CALL
ID: E CH: 4
LOW PWR switch ON-Up Position,
board is put in a low power operating
mode where both LED signal displays
will turn OFF when not needed.
Base side communicates with the
wireless Baseboard of the 1830
series. The Channel and ID of the
Base side MUST match the Channel
and Net ID of the Baseboard.
DO NOT set Base side the same as
the Remote side.
Installation
1/2" thick wall PVC
IMPORTANT:
conduit recommended
Install the repeater
(not supplied).
so the antenna is in a
Metal conduit may
location that is NOT
interfere with wireless
surrounded by metal
signal.
and is in free air as
high as possible above
the ground. Minimum
15 ft above ground
recommended.
Important Antenna Note:
Antenna range WILL VARY
GREATLY depending on individual
setup: Antenna height above the ground, background signal
interference, physical obstructions (trees, buildings etc.).
Adverse weather (rain) CAN also affect antenna range.
Range testing is HIGHLY recommended
before FINAL installation.
Base Side
ID
LOW PWR
4
ON
BASE
SW1
BASE
RF RANGE
BASE SIGNAL
BASE
PROGRAM
Black - NEG
12VDC INPUT
-
+
2372-011
Red + POS
Rev "C"
Power
or higher
Supply
Circuit
12VDC
Board
Power Transformer
18 GA. Wire 100 ft max
16 GA. Wire 200 ft max
Wire Polarity Matters!
Note: Rev "B" circuit board uses 5VDC.
TELEPHONE ENTRY SYSTEM
SP
SP
ABC
ABC
1 1
2 2
GHI
GHI
4 4
JKL
5 5
JKL
PQRS
PQRS
7 7
TUV
TUV
8 8
OPER
OPER
0 0
OPERATING INSTRUCTIONS
1.
Use "A to Z" Buttons to Locate
Name and Code Number on Display.
Names are In Alphabetical Order.
2.
T o Call, Enter Code Number on
Keypad or Press "Call" Button. If
Line is Busy, Press "#" or "Call" to
Hang Up. Try Again.
3.
E nter on Open Display and Tone.
Baseboard
500 ft
Remote Side
CH
ID
CH
4
4
4
REMOTE
D2
D10
BASE
REMOTE
PAIRED
PAIRED
SW5
REMOTE
REMOTE
PROGRAM
RF RANGE
POWER
RF Range:
Set as shown.
67
62
72
58
76
52
84
85 MAX setting
50
Near
Far
Cascading Dual Band Repeaters
Up to 5 Dual Band Repeaters (DBR) can be used in a cascade format to extend
signal distance. The Base Side of 2nd DBR MUST match the Channel and ID of
the Remote Side from the 1st DBR and so on.
Make sure the Channel and ID combinations are
UNIQUE for every DBR in the cascade.
ORANGE
Channels
IDs match
match
YELLOW
and both are
and
Channels
IDs match
in cascade
match
and both are
and
unique
IDs match
in cascade
and both are
unique
in cascade
2nd DBR
1st DBR
DEF
DEF
3 3
MNO
MNO
6 6
WXYZ
WXYZ
9 9
HOLD TO SCAN
A
Z
CALL
2358 Wireless
Tracker Board
MUST be set to:
PAIRED
REMOTE
SW4
REMOTE SIGNAL
BASE
REMOTE
RF STRENGTH
Remote side communicates with
the wireless Tracker board. The
Channel and ID of the Remote
RF SYNC
side MUST match the Channel
and Net ID of the Tracker board.
DO NOT set Remote side the
RF LOST
2373-010
PURPLE
Channels
BLUE
match
and
Channels
IDs match
match
GREEN
and both are
and
unique
Channels
IDs match
in cascade
match
and both are
and
unique
in cascade
unique
4th DBR
3rd DBR
Note: DoorKing offers a Wireless Test Range
Kit (P/N 1514-130) to allow easy testing of
the wireless signal between 2 devices at
chosen locations BEFORE installation of the
devices. The self-powered test kit measures
the wireless signal between 2 devices in ANY
chosen locations. Ensuring that a good signal
can be achieved before installation occurs.
DoorKing Part Number
2372-080
Example:
The wireless
tracker board
ID: 2 CH: 9
same as the Base side.
PINK
Channels
match
and
IDs match
and both are
unique
in cascade
5th DBR
Tracker